Hyno Energy. 6500mAh 158.4V by 11 Sets of Battery Cells, For Honda Accord (2009-2012) Original China Factory
Micro and Mild Hybrids
Many new models incorporate some level of electrification, the best known of which is start-stop. Larger battery packs can also provide extra torque and power up driver-assist and active safety systems. An emerging technology, 48-volt batteries can provide much of the fuel efficiency benefits of full hybrids at a fraction of the cost. There aren’t currently any models using 48-volt technology in North America, but automakers are starting to roll them out in other markets and they are likely to be in the U.S. in the next several years.
Test Conditon
This specification is applicable to Ni MH battery for hybrid produced by Hunan Hi-soon Supply Chain Co., Ltd.
Tests should be done within one month of receiving the goods under the following conditions.
Test condition
Temperature:20±5℃
Relative Humidity:65±20%
Atmospheric Pressure:86～106kPa
Standard charge discharge specification
Discharge: 6000mA (1C) to 12.0V
Charge: 6000mA (1C)×1hrs,1200mA (0.2C)×1hrs
Discharge: 6000mA (1C) to 12.0V
Technical Specification
| Battery Module |
| Description |
Original |
Replacement |
| Voltage |
14.4V |
14.4V |
| Capacity |
6.5Ah |
6.5Ah |
| Length |
380mm |
380mm |
| Net Weight |
2040g |
2040g
|
The whole battery pack consisted by 11 set of above modules
Cautions of Battery Pack Transportation and Storage
- Avoid violent vibration and external force impact, don’t cast, roll, invert, extrude, and stack too high during handling and transportation of battery pack.
- Protect the battery pack from rain during the transportation, and the ambient temperature is not over 55℃.
- Store the battery pack in a cool and dry place and the temperature range is 5-25℃ when you are not using it.
Maintenance regulations (Maintain the whole battery pack, and cool with a fan during the charge and discharge process)
The SOC of our battery pack is 60%~80% when leaving the factory, in long-term storage, battery should be stored in a charged state (usually the SOC is 80%). Have a charge and discharge maintenance to battery pack when the storage time is over 6 months or battery module’s voltage is 15V,to prevent the battery performance’s decline caused by the self-discharge. The maintenance regulations are as follows:
- Discharge: 2A discharge to 204V (that is to say: single cell 1.0V)
- Interval: 30 minutes
- Charge: 1.3A charge for 5 hours (voltage ≥ 306V, -ΔV ≥ 0.2V and temperature ≥50℃)
- Interval: 1hours
- Discharge: 2A discharge to 204V (that is to say: single cell 1.0V)
- Interval: 30 minutes
- Charge: 2A charge for 2.4 hours
Installation Cautions of battery pack
Notes: Installing this product should only be attempted by a qualified technician, the voltage of the battery pack is very high, which has the shock hazards, so when installing the battery pack, you should wear insulating gloves and use insulated handle tools.
- Please operate according to assembly manual during the installation of Prius battery pack.
- Do not mix our battery modules with those of other manufacturers, or new battery modules in use with semi-used battery modules, and don’t mix battery modules within a battery pack with those in other battery pack.
- Don’t twist and bend battery modules and accessories when assembling battery pack.
- Don’t connect the anode and cathode of battery module in reverse when assembling battery pack, to prevent short circuits.
- Fasten bolts and nuts with appropriate torque, avoid loose connection or damaging other accessories with too big torque.
Hunan Hi-soon Supply Chain Co., Ltd reserves the right to change and revise Product specification without any advance notice.
